Buy Yamaha Outboard Parts

Announcement

Collapse
No announcement yet.

Yamaha tachograf problems please help!

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #61
    it is possible to control if all my engine sensors are ok?(without computer tester- just a home made test) i am interest if wather in gas sensor is working and wather sensor. not only senzor (if it is ok ) but also the network who do this.( wires, ecu, buzzer...etc..) a test for functionality of all warning sistem i wont.
    thanks!

    Comment


    • #62
      it is certainly posisble, Boscoe has posted of this many times.

      the buzzer is easily heard by pulling the safety lanyard while running!

      or - before the engine is started: it will sound once you begin to "crank"


      I think the water-in-fuel is easiest to test, if you so wish
      since the engine does not need to be running to activate the alarm
      disconnect the bowl sensor
      use a piece of wire to "short" the contacts on the engine harness side

      the over-temp and oil warnings can be somewhat model specific and a bit more involved

      lets see what Boscoe says for your model....

      Comment


      • #63
        round speed fuel gauge

        Hello, i have intention to buy a gauge -speed fuel -the round one ( the new model with round buttons ) and need yours advices: it is necesary an optional sensor for fuel flow ( the gauge show me fuel flow, ttl , econ, etc..)? it is included ( the sensor for fuel flow) in engin part( as standard ) and it is displays by nmea 2000 network right now? or it is necessary optional sensor?

        thanks in advance !

        sorry for language mistake!
        if i post wrong please sorry but i belive is a subject near the previously

        Comment

        Working...
        X