Hi all, I bought a used 2020 F25SWHC tiller model and am converting to a remote set up with the 703 side mount remote control. The mechanical part is hooked up but I don't seem to have a 10 pin connector for the electrical harness on my engine??? does anyone know what what I am missing? can't seem to find anything on the internet for this situation, and the install manual for the 703 remote control doesn't mention anything about wiring ... thanks
Announcement
Collapse
No announcement yet.
2020 f25swhc tiller to 703 remote conversion
Collapse
X
-
Comment
 -
Comment
 -
Comment
 -
Originally posted by boscoe99 View PostTrying to post info but system is holding it pending approval. WTF!
Comment
 -
Thanks 99yam40. so I guess the tiller model does not come with a 10 pin connector only a remote model? To use the keyed ignition switch, warning buzzer and engine lanyard shut-off at the remote control I would need to install the engine wire harness for a remote model engine. Does that sound correct?
Comment
 -
Is there a connector between the tiller handle wiring and the motor wiring? I don't think so but you are there.Last edited by boscoe99; 05-30-2023, 02:42 PM.
Comment
 -
no there is not a 10 pin connector attached to the tiller only a couple leads for the engine cut-off
Comment
 -
Comment
 -
Comment
 -
Originally posted by boscoe99 View PostThis site is becoming too onerous to use.
Comment
ÂÂÂÂÂÂÂÂÂÂÂÂÂ
Comment