Buy Yamaha Outboard Parts

Announcement

Collapse
No announcement yet.

Doesnt start

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Originally posted by John16610 View Post
    I have a 2000 115 TXRY which is used in salt water and is in a boat lift making it very hard to flush using muffs. .

    John
    You want to consider putting lift extensions on the lift. It makes any maintainance MUCH EASIER;

    Scott
    1997 Angler 204, Center Console powered by a 2006 Yamaha F150TXR

    Comment


    • #17
      I had thought of that but I was trying to find "an easy way out". Your set up looks great. I'll look at my lift again to see if there is a practical solution.

      Thanks, John

      Comment


      • #18
        Originally posted by John16610 View Post
        I had thought of that but I was trying to find "an easy way out". Your set up looks great. I'll look at my lift again to see if there is a practical solution.

        Thanks, John
        Thanks. The galvanized extensions were about $250 each.

        All the walk around PT planks, I stained and installed. Makes washing, changing oil change, etc, MUCH easier, especially in the shade!
        Scott
        1997 Angler 204, Center Console powered by a 2006 Yamaha F150TXR

        Comment


        • #19
          Scott... Well, that is just TOO nice! It's almost like cheating!

          No balancing on one leg with the other extended out behind you for a counter balance... no pushing yourself to reach just a "little bit" further... Very cool setup.
          2000 Yamaha OX66 250HP SX250TXRY 61AX103847T
          1982 Grady Weekender/Offshore (removed stern drive & modded to be an OB)

          Comment

          Working...
          X