If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
So I was cruising along at night and then *SMACK* right into patch of coral and snapped a blade off my 40hp Enduro (2004 model) propellor. Is it a 14mm spline? And will a 19 pitch prop replace it?
Props need to be of the correct size and pitch for your motor and boat, so that the motor reaches the proper RPM with the load you normally run. It is normally the best to get a new one just like you had before, unless it was not sized correctly before
Tweet
Comment