Starter install gone wrong.. 07 225 hpdi

[TownsendsFJR1300]

Part #36 , the main fuse (a 60 amp fuse) ? :

(or 38 or 39)


https://www.boats.net/catalog/yamaha...7/electrical-3



Capture.JPG ? :

[99yam40]

thinking about this more, if it was the main pos battery cable that went to ground, it should not have to go thru a fuse, so not sure what you did to something

[Yammerjammer88]

always good to disconnect the battery before doing any work on a 12 volt system be it car ,truck, ATV, or boat etc..

there should be a fuse,
your service manual should have wiring diagrams,
but I am of no help as to where to find them on that motor itself,
others should show up to direct you soon

And it crossed my mind to disconnect it but I didn’t .. shoulda coulda woulda in action

[99yam40]

always good to disconnect the battery before doing any work on a 12 volt system be it car ,truck, ATV, or boat etc..

there should be a fuse,
your service manual should have wiring diagrams,
but I am of no help as to where to find them on that motor itself,
others should show up to direct you soon

[Yammerjammer88]

Hopefully one of you have had this same problem and can help.. I have a 2007 225 hpdi and I was replacing my starter and I let the positive lead touch the block and it arced out and now I have no power.. let won’t do anything and I also don’t have trim or gauges. It has to be a fuse right?? I can’t seem to find it if so..