F300 - flywheel puller needed?

[28Regulator]

Anyone know if a flywheel puller is needed to get the flywheels off my F300s? F300s were made in 10/13, and are approaching 1100 hours (going to replace the timing belts). Thanks

[boscoe99]

Puller is not needed. Simply remove six bolts. The flywheel will lift off.

[28Regulator]

Thanks much!

[panasonic]

Puller is not needed. Simply remove six bolts. The flywheel will lift off.

Are these high strength, close tolerance bolts? Are they reusable?

[rodbolt17]

DO NOT reuse the bolts.

[28Regulator]

DO NOT reuse the bolts.

Got it. Thanks. The new timing belts come with the 6 replacement flywheel bolts, and the service manual seems to do a good job explaining things, as this will be my first time doing this. I'm assuming it's ok to take these bolts off with an impact?

[rodbolt17]

I remove them with an impact.
not a hard job, time is about 4 hr. make sure you follow the manual when setting it up for belt removal.

[boscoe99]

Can they be reused? Yes,

Should they be reused? Yamaha says not to. Apparently torque to yield.