SX150TXRY Tilt Stop Lever

[FabricGATOR]

My tilt stop levers are getting hard to move. I do not see a grease point and wish to disassemble, clean, repair, lubricate.

Items 29, 30, 31 on Bracket 1 in IPC

Thank you.

OK, prior to posting this, I checked the MMM and see that I probably need to fiddle around in the vicinity of the spring to release the two halves.
'
Now my question, is it possible to disassemble, clean, repair, lubricate the tilt stop levers while the powerplants are installed on the vessel (under normal or most circumstances)?

[rodbolt17]

yes.
its entirely possible.
pain in the rear.
but do it now while they still move.

[FabricGATOR]

Pia

Roger that.
That's exactly what I was thinking, should be addressed now while I can still move them by hand.

Thanks.

[FabricGATOR]

That wasn't too bad

Once I fashioned a roll pin driver from a drill bit, that wasn't too hard to disassemble.

Of course, now I need some parts. Mainly fresh bushings and a replacement roll pin. Boats.net!