Valve and Camshaft install Warning Honda Content!

[panasonic]

A good video I think.

https://youtu.be/sPMCdPZzk1s

[boscoe99]

Thanks for the link.

I appreciate the time that some folks take to produce these videos.

[boscoe99]

I like that guy. Wish I could meet him and share a beer. He talks funny but...

Here is another good video. Stuff he talks about is discussed here quite a bit.

https://www.youtube.com/watch?v=bsHCMJnRY9A

[panasonic]

He is pretty crafty and sometimes a bit rough on the gear, but a good teacher. I subcribe to his videos and have seen them all...

I bet he thinks you crowd from merica talk funny as well....lol

[99yam40]

I would have thought that once you balance the vacuum by changing the plates opening, you would need to go back and re adjust the mixture screws since the plates have moved.
Am I wrong?

[boscoe99]

I am going to forgive him for his use of that nasty word "vacuum". You too 99yam.

[pstephens46]

I am going to forgive him for his use of that nasty word "vacuum". You too 99yam.

99yam is busy watching the halftime show.

[boscoe99]

I would have thought that once you balance the vacuum by changing the plates opening, you would need to go back and re adjust the mixture screws since the plates have moved.
Am I wrong?

It might not hurt to recheck the mixture screws. Then, you might need to go back and recheck the manifold pressure of each cylinder. And then recheck the mixture screws. And then recheck the manifold pressure. One can, repeat can, not necessarily will, affect the other.

I am surprised to see him doing what he does based on his ear, rather than using a good digital tachometer to detect the engine RPM change as each carburetor gets adjusted. But I live in a glass house and don't throw stones. As I said, I appreciate the time and effort he puts forth in creating these and then sharing them with us.

[boscoe99]

99yam is busy watching the halftime show.

I just came home from the neighbors house. He just got ROKU and was using it to watch the ****. His inner web speed must have been way down. The picture was lost over and over again. Appeared to be a buffering problem. Don't think the data was coming in fast enough to continuously display the picture.

[pstephens46]

I just came home from the neighbors house. He just got ROKU and was using it to watch the ****. His inner web speed must have been way down. The picture was lost over and over again. Appeared to be a buffering problem. Don't think the data was coming in fast enough to continuously display the picture.

That would stink if GA and AL were playing. This is probably a good event for testing.

[99yam40]

Yes I thought about the use of a tach also while watching .
it is called fine tuning after all

[almetelo]

By videos of outboards mokanics

These "kids" do really nice videos and they work using old school type method

https://www.youtube.com/channel/UCVM...GIGO7EiI7ZlDlw

I dont understand a word but wort it anyway IMO

I have learned a few things from them even not understanding what they say...

Found this YT channel by these 2 videos

https://www.youtube.com/watch?v=njMPJVdkZz0&t=203s

https://www.youtube.com/watch?v=Py-sT_BSH20


Most of the time they work on "small" motors and do lot of mods as convert a long shaft motor to short shaft

[panasonic]

Some good videos for sure....thanks for sharing.

[panasonic]

This topic is closed.....really.