Tweet
Anyone know y a tilt trim motor would just stop working?
Not a fuse.
Button makes loud klick and nothing!
Not a fuse.
Button makes loud klick and nothing!
-
-
It was working fine I was tilting it up and it just stopped!
No funny noises or anything, just stopped! -
Checked motor leads nothing, bad motor.
New one is $627.30 from yamaha.
OUCH THAT HURTS!!!Comment
-
most likely the thermal overload contacts are open.
may be repairable.Comment
-
Thank you rodbolt I've got it apart right now and one of the brushes was seized. cleaning it up now! There was a lot of black dust build up but the brushes were barely worn. Is that normal?Comment
-
Got the motor reinstalled it works great!
It didn't at first but I found out y, when you replace your tilt trim motor make shore you get your connector, shaft (#91 on parts diagram) lined up or your new or rebuilt motor will be about as useful as teats on a boar hog.Comment
-
Yamaha
4-G--0618 6D8-00
Power tilt and trim ass.
Those are the part numbers that I've been working on, thought it would be relevant if someone would have the same problem. I saved myself over $700 dollars in parts and labor. Hopefully someone else can do the same.
Boats are expensive enough without spending money on a little bit of dust build up.Comment
Comment