Tweet
Planning to fog down the cylinders .
You'd have laughed if you'd have seen me looking for the plugs.
When I found them I laughed. Not my 1982 40hp Yamaha. LOL
Finally followed the plug wires , removed some screw from the plug cover & looked down the tunnel at the plugs.
They were barely snug, just over hand tight.
No signs of blow by.
Gap was .044 - 45. (book .039 - .043) So ok.
Gotta get some fog spray tomorrow, may replace plugs too.
Any plug readers here?
Look like they need replaced?
You'd have laughed if you'd have seen me looking for the plugs.
When I found them I laughed. Not my 1982 40hp Yamaha. LOL
Finally followed the plug wires , removed some screw from the plug cover & looked down the tunnel at the plugs.
They were barely snug, just over hand tight.
No signs of blow by.
Gap was .044 - 45. (book .039 - .043) So ok.
Gotta get some fog spray tomorrow, may replace plugs too.
Any plug readers here?
Look like they need replaced?
Comment