Tweet
I have a fuel issue and can't lay a finger on it. The motor will start each day and run for 2-3 minutes then get rough and shut down. Will not fire again until next day. Started realizing that gas was pouring out of my lower end/exhaust. Pulled the plugs and they were all soaked. Turned motor over and blew out the cylinders. Lot of gas blew out especially the lower cylinder on both sides. I seem to be flooding out but how is that possible on a fuel injected motor? High pressure pump does stop and is not constantly running so I don't think I have a stuck injector but??? Anyone with similar problem or can anyone guide me on what to do next?
-
-
Test low pressure pumps, without solid flow it (could ) make hp pump run extra
Could also be injector
Could be float is stuck in vst
Have you tested rail pressureLast edited by jb123; 08-09-2013, 10:25 PM. -
VST needle or most likely a blown fuel lift pump diaphram.
CAREFUL spinning the motor over to clear fuel.
a tech at the shop got to discharge a fire bottle doing it last week.
gave a new meaning to"fire it up man".Comment
Comment