Buy Yamaha Outboard Parts

Announcement

Collapse
No announcement yet.

2003 F225 Trim cylinder seal replacement

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • marchmadness
    started a topic 2003 F225 Trim cylinder seal replacement

    2003 F225 Trim cylinder seal replacement

    I am looking to replace the trim cylinder seals on my motors. I was wondering if its sold as a kit or individually . Also opinions on which tool members recommend to remove the caps.

  • marchmadness
    replied
    I just wanted to update my post. I did purchase the marine tech tool and I can say it was worth the price. one of the hardest parts was getting out the dust seals. They were so far gone it took a while to dig them out. I replaced the o rings and dust seals.

    Leave a comment:


  • pstephens46
    replied
    Fred Flintstone. Can't believe it worked. Save 70 bucks, worth a try.

    Leave a comment:


  • fairdeal
    replied
    several variables possible in that model; the SM calls for an install torque of 115 lb-ft for the trim ram caps
    (but "only" 65 lb-ft for the tilt ram cap)

    and actual removal torque required is a wild card - given the potential for corrosion


    when I replaced the trim seals on my F225 TXRD in 2016 -
    a homemade (hardwood) spanner worked fine
    (although I seriously doubt that I achieved 115 lb-ft on reassembly)



    when I later changed the tilt ram seals, I used the Marine Tech tool - a very pretty tool!




    I suspect, though, that the best style is the Yamaha tool

    https://www.simyamaha.com/Yamaha_Tri...h_p/ytrim2.htm




    Leave a comment:


  • marchmadness
    replied
    I was looking at the parts list, should I be replacing the oil rings or all the pieces(clips,springs etc).

    Leave a comment:


  • pstephens46
    replied
    Watch the video at Marinetechtools.com
    Notice the "cheater" bar he uses.

    Leave a comment:


  • boscoe99
    replied
    No kit. Parts are sold as needed.

    Leave a comment:

Working...
X